Choose your country of delivery to see prices and products for your location.
Choose tax zone / country of delivery
1 NO contact not potential-free 10A/250V AC, 230V LED lamps up to 600W, ESL up to 200W, incandescent lamps up to 2000W. Switch-off prewarning and push-button permanent light can be switched on. Stand-by loss only 0.7W. With ESL optimisation. For recessed mounting. 45mm long, 45mm wide, 18mm deep. Zero-crossing contact switching to protect contacts and lamps. In particular, this prolongs the life of energy-saving lamps. Due to the use of a bistable relay, there is no coil power loss and no heating even when switched on. After installation, wait for the automatic short synchronisation before connecting the switched consumer to the mains. Control, supply and switching voltage 230V. Time setting 1 to 12 minutes. Glow lamp current up to 50mA, depending on the ignition voltage of the glow lamps. For 3- and 4-wire circuits, can be switched subsequently, with attic lighting for 4-wire circuits. Automatic recognition of the circuit type. After a power failure, the lighting is switched on again if the timeout was not yet completed. If the switch-off early warning is switched on, the lighting flickers approx. 30 seconds before the time expires and a total of 3 times at increasingly shorter intervals. If the permanent light button is switched on, pressing the button for longer than 1 second can set it to permanent light, which is automatically switched off after 60 minutes or can be switched off by pressing the button for longer than 2 seconds. If the continuous pushbutton light and the switch-off early warning are switched on, the switch-off early warning is activated after the continuous light has been switched off. If energy-saving lamps ESL are switched on completely or partially, then set the switch-off early warning with push-button permanent light ESL on the lower rotary switch. Within the first second after switching on or after switching on, the time can be extended for the TLZ functions by briefly pressing up to 3 times (pumping). Each key adds 1 time to the set time. Switchable to the ESV function, impulse switch with off-delay up to 120 minutes. In this function, the unit is switched off automatically after the adjustable delay time has elapsed if the manual off command has not been given. If the delay time is set to minimum in the ESV function, the off-delay is switched off and the normal impulse switch function ES results.
There are no reviews yet.