Combi switch/shutter actuator 8 to 24gang, 16 A, REG, extension SpaceLogic KNX switch/shutter, 8gang extension 8 switch outputs 4 shutter outputs: The function of the shutter or switch channels is freely configurable. All blind switching outputs can be operated manually via push-buttons. ETS programming is carried out in the ETS application of the master. The master controls the function of the extension, the power supply and the communication to the KNX bus. A maximum of 2 extensions can be connected to the master (MTN6705-0008), so that up to -24 loads can be switched or -12 blind drives can be controlled. Supply voltage via the master: KNX bus, approx. 6.5 mA (master), approx. 9 mA (master + 1 extension), approx. 12.5 mA (master + 2 extensions). All outputs can be operated manually via the keypad of the master.On the extension, a green LED indicates operational readiness, a red manual operation LED indicates whether the extension is controlled manually. For mounting on DIN rails TH35 according to EN 60715. Connection to the master or another extension is either via a module connection or via a cable connection. KNX software functions: The functions are set in the KNX application of the masterGeneral KNX software functions: Energy saving, device safety, device status, manual operation, PIN code for firmware update. In the event of a defect, the extension can be replaced with a new device without having to reprogram the device via the ETS. Functions of the blind/roller shutter actuator: -running time -idle time -step interval -blocking function -movement range limits -weather alarm -8-bit positioning for height and slats -16 scenes. Status and feedback function per channel. Switch actuator functions:-Operation as normally closed/ normally open -Programmable behaviour for download -Delay functions for each channel -Staircase lighting function with/without manual OFF function. Switch-off prewarning for staircase lighting function -16 scenes per channel, central function, disable function, logic operation or priority control, feedback function for each channel. Rated voltage: AC 250 V, 50-60 Hz Rated current: 16 A AC-1, IEC 60947-4-1 / 10 A, IEC 60669-2-5For each blind roller shutter channel: -Motor load 1000 VAFor each switching output Rated load: - Incandescent lamps: 2300 W -Halogen lamps: 2300 W. LED: 200 W -Capacitive load: 10 AX, max. 140 ?F -Inductive load: 10 A, cos? 0.6 Relay data -Inrush current: max. 800 A/200 ?s, max. 165 A/20 ms. Device width: 4 TE (72 mm) Accessories: SpaceLogic KNX switch/blind extension MTN6805-0008. Contents: With bus connection terminal.
