Choose your country of delivery to see prices and products for your location.
Choose tax zone / country of delivery
• 2 contactors potentialfree 16A/250V AC, 230V LED lamps up to 200W, incandescent lamps 2000W. No standby loss. DINEN 60715 TH35 railmounting railmounting device. 1 pitch unit = 18mm wide, 58mm deep. Either universal control voltage 12..230V UC at control input +A1/A2 or 230V with up to 5mA glow lamp current at control input (L)/A2(N). The simultaneous use of two potentials at the control inputs is not permitted. Very low switching noise. No permanent power supply required, therefore no standby loss. Stateoftheart hybrid technology combines the advantages of wearfree electronic control with the high performance of special relays. By using a bistable relay, there is no coil power loss and no heating even when switched on. The relay contact can be open or closed during commissioning and synchronises itself the first time it is actuated. The terminal assignment is identical to the electromechanical bumper switch S12200. Maximum current as a sum over both contacts 16A at 230V. If this bumper switch is located in a circuit that is monitored with an FR12230V field isolating switch, no additional base load is required, but the monitoring voltage of the FR12230V must be set to max. The electronics do not have their own power supply and therefore do not consume any power in either contact position. The control current, which activates the microcontroller, only flows during the short control pulse of just 0.2 seconds. It reads the last switching state from its nonvolatile memory, switches the bistable relay accordingly in the opposite direction and writes the new switching state back to the memory
There are no reviews yet.