Blister pack switching includes a battery-free and wireless radio push-button FT55R in alpine white (without frame) for cover frames Busch Reflex and Duro as well as a switching actuator FSR61-230V with impulse switch function. FT55R-alpin white: Wireless pushbutton FT55R in alpin white for frame internal dimensions 55x55mm with radius, 15mm high. Generates the energy for radio telegrams even when the button is pressed, therefore no connection cable and no stand-by loss. For cover frames Busch Reflex and Duro. The scope of delivery includes a rocker, a double rocker, a mounting frame, a retaining plate (all the same colour), the radio module and an adhesive foil. Wireless pushbuttons with one rocker can send two evaluable signals: Press rocker up and press rocker down. Wireless pushbuttons with a double rocker can send four evaluable signals: Press two rockers each up and down. The mounting plate can be screwed onto a flat surface or glued to the wall, glass or furniture with the enclosed adhesive foil. Above a 55mm switch box, the sleeves provided in the box are used for screw fastening. Then the wireless pushbutton illumination FTB can also be snapped onto the retaining plate from behind. The double rocker is snapped onto the radio module ex works. If this is to be replaced with the large rocker, pull the rocker halves off towards the front and do not bend them towards the centre. Then snap the large rocker onto the radio module so that its 0 and I markings on the back match. When gluing on, first glue on the set of holding plate with frame and fastening frame - with the catches at the top and bottom. Then snap in the set of radio module with rocker - marking 0 on the back always at the top. Before screwing on, detach the frame with the fixing frame from the retaining plate. To do this, press the catches of the retaining plate outwards. Then screw on the retaining plate with the catches at the top and bottom, snap on the frame with the fastening frame and snap in the radio module set with rocker - marking 0 on the back always at the top. For screw fastening, we recommend countersunk sheet metal screws 2.9x25mm, DIN 7982 C. Both with 5x25mm dowels and on 55mm switch boxes. FSR61-230V: 1 NO contact potential-free 10A/250V AC, incandescent lamps 2000 Watt, off-delay with switch-off pre-warning and push-button permanent light can be switched on. Encrypted radio, bidirectional radio and repeater function can be switched on. Stand-by loss only 0.8 Watt. For recessed mounting. 45mm long, 45mm wide, 33mm deep. Supply and control voltage locally 230V. In case of supply voltage failure, the switching state is maintained. When the supply voltage returns, it is switched off in a defined manner. After installation, wait for the automatic short synchronisation before connecting the switched consumer to the mains. In addition to the radio control input via an internal antenna, this radio actuator can also be controlled locally with a conventional control pushbutton that may be mounted in front of it. A glow lamp current is not permitted. As of production week 11/14, encrypted sensors can be taught-in. Bidirectional radio and/or a repeater function can be switched on. Every change of state as well as received central control telegrams are then confirmed with a radio telegram. This radio telegram can be taught-in to other actuators, the GFVS software and universal displays. Scene control: With one of the four control signals of a push-button with double rocker taught-in as a scene push-button, several FSR61s can be switched on or off to form a scene. With the upper rotary switch in the LRN position, up to 35 radio push-buttons are assigned, one or more of which are central control push-buttons. In addition, radio window/door contacts with the function make contact or break contact when the window is open, radio outdoor brightness sensors FAH and radio motion detectors FBH. After that, the desired function of this impulse switch is activated
